PC software eases EMC pre-compliance testing

October 19, 2017 // By Julien Happich
TekBox's EMCView now available from Saelig Company, is a PC-compatible software that simplifies the process of EMC pre-compliance testing of radiated and conducted emissions.

EMCView complements an emissions test setup of a spectrum analyzer, an LISN (Line Impedance Stabilization Networks) and an EMI-quiet TEM (Transverse ElectroMagnetic) Cell. Built-in amplitude correction provides the correction and conversion coefficients for cables, amplifiers, attenuators, LISNs, TEM cells, antennas, RF current probes, striplines and capacitive coupling clamps.
Without any time-consuming setup, the software is ready for measurements immediately after installation on a PC. All emission-related CISPR-xx (EN550xx) measurements, as well as some automotive manufacturer standards are pre-configured in corresponding project files. The resulting graph supports two complete measurement runs, such as Average / Quasi-Peak or Peak / Quasi Peak or alternatively a fast Quasi-Peak scan of critical peaks.

The tool also allows the import and overlaying of reference measurements for comparison purpose and the automatic creation of test reports. EMCview software currently supports spectrum analyzers from Rigol and Siglent, but support for other manufacturers will be added in future software versions. The anlyzers should preferably be equipped with the manufacturer's "EMI option", although it is not essential; if it is not installed, the analyzer will change the preconfigured resolution bandwidths of 200Hz, 9kHz or 120kHz (as specified in the EMC standards) to 300Hz, 10kHz or 100kHz.

Saelig - www.saelig.com


s

Vous êtes certain ?

Si vous désactivez les cookies, vous ne pouvez plus naviguer sur le site.

Vous allez être rediriger vers Google.