Si2 to form 3-D IC standards group

April 26, 2011 // By Mark LaPedus
The Silicon Integration Initiative (Si2), an organization focused on the development and adoption of standards to improve IC design, is quietly forming a standards group for 3-D chips.

The so-called Open3D Project will enable interoperable 2.5-D/3-D design and EDA flows with open standards, according to Si2.

Over a dozen companies are interested in the effort, which hopes to devise standards for 3-D chips based on through-silicon vias (TSVs), according to Si2. Si2 is an organization of industry-leading companies in the semiconductor, electronic systems and EDA tool industries.

The plan is to have a ''kickoff meeting'' at the upcoming Design Automation Conference (DAC) In San Diego, the group said. DAC will be held June 5-9. The goal is to set the initial standards by Q1 of 2012.

Many wonder if mainstream 3-D chips based on TSV technology is feasible-or will even fly-amid ongoing problems in the arena. The progress remains slow and the technology still appears to be in the ''power point’’ stage.

Still, a plethora of others are also scrambling to develop TSV-based technology-and for good reason: There are fears that IC scaling is becoming too costly for most chip makers-or will end in the distant future.

So instead of scaling, there is another concept on the table: stack and connect existing devices in a 3-D configuration using TSVs. For years, chip makers have been talking about 3-D chips based on TSVs. But except for select products-such as CMOS image sensors-the technology has not moved into the mainstream, due to costs, lack of standards and other factors.

In theory, 3-D chips could evolve in two steps. The first step is a 2.5-D scheme using silicon interposers. Then, eventually, the industry could move to 3-D TSV-if it can solve the multitude of problems with the technology.

In 3-D packaging, the lines blur between front-end manufacturing and packaging. However, many of the IC-packaging houses say have no plans to do the actual TSVs, that is, drilling and filling the holes. That, according to some, will be left up to the foundries.

Ultimately, the subcontractors will join forces with the foundries