Arduino boards give LoRa low-power WAN and 2G/3G connectivity to IoT
The Arduino MKR WAN 1300 delivers LoRa low-power WAN connectivity, and the Arduino MKR GSM 1400 adds global 2G/3G communications capability. Both 67.64x25mm boards are low power, making them suitable for emerging battery-powered IoT edge devices in the MKR form factor.
Offering 32-bit computational power similar to the Arduino MKR Zero board, the MKR WAN 1300 is based around the Murata LoRa low-power connectivity module and the Atmel SAM D21 microcontroller, which integrates the 32-bit low-power ARM Cortex-M0+ processor, 256KB Flash memory and 32KB SRAM. The board’s design includes the ability to be powered via either two 1.5V AA or AAA batteries or an external 5V input via the USB interface – with automatic switching between the two power sources. Other features of the board include an operating voltage of 3.3V; eight digital I/Os; 12 PWM outputs; and UART, SPI and I2C interfaces.
The MKR GSM 1400 is also based on the ARM Cortex-M0+ based SAM D21, but integrates the u-blox module to deliver global 3G communications ability. The board also features automatic power switching, however, it uses either a 3.7V lithium polymer (LiPo) battery or an external Vin power source delivering 5V to 12V. While the USB port can also be used to supply 5V to the board, the MKR GSM 1400 is able to run with or without the battery connected. The MKR GSM 1400 also offers a rich set of I/O interfaces including: eight digital I/Os; 12 PWM outputs; UART, SPI and I2C interfaces; analogue I/O including seven inputs and one output; and eight external interrupt pins.
Arduino – www.arduino.cc
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
