Carbon footprint floating solar systems similar to land systems
Floating solar systems on inland waters are, in terms of carbon footprints, similar to solar systems on land
Josco Kester, Scientist at TNO: “Our study of two operational systems in Western Europe shows that, from the point of view of greenhouse gas emissions over the complete life cycle, floating PV systems on inland water bodies can be a good addition to ground-mounted PV systems. If the degradation of the PV modules is limited, the carbon footprint of these systems is 3-4 times lower than the EU grid mix target for 2030.”
Floating solar energy is a relatively new, but rapidly growing segment of the photovoltaics (PV) market. So far, no detailed life cycle inventory (LCI) analysis is available. The report focusses on the carbon footprint, which is the total greenhouse gas emissions during the whole life cycle, from production and installation until waste treatment or recycling at the end of life. It compares two operational floating solar energy systems to hypothetical ground-mounted systems that are modelled using background data. The floating solar systems are two commonly used systems with different floater compositions (high-density polyethylene or HDPE and steel/HDPE). They are installed on inland water bodies with very low wave height in the Netherlands and Germany.
Key results
- The estimated carbon footprint per kWh energy yield of the two floating solar energy installations is about 50 g CO2/kWh, which is 3-4 times lower than the EU grid mix target for 2030 (176 g CO2/kWh).
- During their life cycle floating solar energy systems on inland water have similar CO2 emissions to land-based solar systems. Compared to an east-west system on land the carbon footprint of the floating solar energy systems is only 15% higher than that of a ground-mounted PV system. This makes floating solar systems a viable addition to the energy mix.
- The carbon footprint can be further reduced by over 40% through three measures:
- Manufacturing PV modules with low-carbon electricity sources.
- Using recycled materials for the support structure.
- Recycling HDPE at the end of life.
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
