Configurable interleaved Power Factor Correction controller simplifies designs
In high-power applications above 1 or 2 kW, interleaved CCM PFC (Continuous-Current Mode, Power-Factor Correction) topologies are mandatory to handle such power levels with reasonable magnetic volume and current split. The quest for higher efficiency, connectivity, and configuration options encourages the use of expensive and complex DSP solutions.
The STNRGPF01 SMPS controller for interleaved boost-PFC topologies is configured quickly and easily using ST’s eDesignSuite online design environment, and has I2C and UART interfaces for monitoring and control. It supports three interleaved phases, which ensures low ripple currents, simplifies EMI-filter design using small-size inductors, and permits a wide power range from 500W to over 20kW. The configurable phase-shedding strategy optimises the number of active phases automatically to maintain high efficiency across all load conditions.
The controller operates in CCM at fixed frequency with average-current-mode control. A hardware inner-current loop ensures accurate cycle-by-cycle regulation, while a digital proportional-integral (PI) controller manages the outer voltage loop to ensure fast dynamic response. The frequency can be programmed from a few kHz to over 300kHz, to control either an IGBT or MOSFET output stage. Other configurable features include inrush-current limiting and PFC soft power-on.
By delivering the advantages of digital power through easy configuration in eDesignSuite, the STNRGPF01 enables superior flexibility, reliability, safety, and energy efficiency in equipment such as industrial welders, motor drives, pumps, uninterruptible power supplies (UPS), industrial or consumer air conditioners, and domestic appliances such as refrigerators, washers, dryers, and cookers.
ST’s design methodology allows designers to enter the converter specifications in eDesignSuite and run the configurator to automatically generate the schematic, bill of materials (BoM), and downloadable firmware to configure the IC, avoiding the need to understand processor memory and interrupt structures or write code to implement the required functions in a DSP.
The STNRGPF01 is in full production, packaged as a TSSOP38, priced from $3.50 for orders of 1000 pieces.
For further information please visit www.st.com/stnrgpf01
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
