Customizable embedded driver stage for NEMA 17 stepper motors
Pre-programmed and pre-configured with all operating parameters to support standard 1.1A (rms) motors, the board is intended for rapid design-in and off-the-shelf use without any additional programming required.
With its optional programming kit, the TMCM-1043 becomes a fully customizable smart driver stage allowing for adaption to a broad range of embedded motion control and mechatronics requirements. In addition to a desktop programmer kit with an intuitive GUI for evaluation and ideal parameter selection, a volume programmer for quick parameterization of production scale quantities will also be available.
The TMCM-1043 incorporates the TMC2660 stepper motor driver IC, which integrates power MOSFETS with the industry’s lowest RDS(on) specification, resulting in minimal power dissipation. The PCB also integrates all required protection circuitry and interface hardware into a compact and robust assembly.
The TMCM-1043 is pulse controlled for 16 microsteps per full step. Trinamic’s patented proprietary interpolation processor interpolates these steps to a resolution of 256 microsteps per full step, allowing for a smooth and noiseless movement.
Visit Trinamic at www.trinamic.com
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
