Front-end AC-DC PSU delivers 1300W
The D1U3CS 1300 series has a 108 to 264 VAC universal input, is hot pluggable, has no minimum load requirement, and incorporates low-loss integral OR-ing FETs on its main 12 V output, for fault-tolerant and N+1 redundant applications. With a power density of 23W per cubic inch, the power supply can achieve a typical conversion efficiency of 92% at half full load.
The D1U3CS-W-1300F has a primary 12 VDC output and an optional auxiliary output of either 3.3 VDC, or 5.0 VDC for powering standby circuitry. Active power factor correction is used to minimise input harmonic current distortion and ensure compliance with the IEC61000-3-2 standard, with a power factor of 0.99 typical. It accepts the universally available IEC C14 AC input power connector.
Digitally programmable, both models are equipped with an I²C interface and support the industry-standard PMBus communications protocol. Both also contain a memory device (EEPROM) that is pre-programmed with data about the unit.
With active single-wire current sharing, multiple supplies can be paralleled for very high current applications. The supplies incorporate fan cooling with automatic speed control and have an ambient operating temperature range of -10 to +50C. It is comprehensively protected against overload and overvoltage conditions and has a mean time between failures (MTBF) of more than 500,000 hours. The power supply meets the EN55022-B and FCC part 15 Class B conducted and radiated emissions standards, and holds a full complement of international safety certifications including CE Mark, CSA and TUV.
Typical applications for the D1U3CS series include systems using distributed power architectures, such as computing, storage, networking, data centre, and test and measurement systems.
Murata Europe; www.murata.com
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
