Fully differential IF 15-dB RF/IF amplifier achieves 50-dBm OIP3

Fully differential IF 15-dB RF/IF amplifier achieves 50-dBm OIP3

New Products |
By eeNews Europe

Two performance grades of the LTC6430-15 are available: at 240 MHz, the A-grade OIP3 is typically 50 dBm and is fully tested and guaranteed to be a minimum of 47 dBm. Noise Figure is 3 dB, which corresponds to an input-referred amplifier noise of 1nV/√Hz.

DC power consumption is 800 mW. The combination of low noise and low distortion provides wide dynamic range needed for high performance intermediate frequency communications and CATV applications.

The LTC6430-15 is easy to use, it is unconditionally stable, and the input and output are internally matched to 100Ohm differential. With greater than 2.75 VP-P linear output swing, it is well suited for driving high speed, high performance ADCs. Two 1:2 baluns, DC blocking capacitors, and RF bias chokes are all that is needed externally to achieve a wideband 50 Ohm balanced amplifier in communications applications. With two 1:1.33 baluns, the LTC6430-15 can be used as a high fidelity 75 Ohm CATV amplifier. P1dB is typically 24 dBm.


The LTC6430-15 is available in a 4 mm x 4 mm QFN-24 package with exposed pad for best thermal performance and low inductance. The device is specified for operation from -40°C to 85°C case temperature. Pricing starts at $6.44 each for the A-grade version and $3.69 each for the B-grade in 1,000-piece quantities.

More information about the  LTC6430-15 RF/IF amplifier at

If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :    eeNews on Google News


Linked Articles