Hall effect sensors integrate primary winding

Hall effect sensors integrate primary winding

New Products |
By eeNews Europe

The potted devices feature a high isolation voltage of 3kV and is suitable for nominal currents of 5, 10, 15, 20, 25 and 50A. The output signal is centred at 0V with an output voltage of ±4 V allowing the detection of currents up to 3 times nominal value. It also provides a linearity of less than 0.1% with an accuracy of a ±0.7%. Bandwidth is up to 150 kHz with a response time below 1us, while offset drift versus temperature is as low as 0.5mV/ºC.

Get the datasheet

Visit Premo Group at

If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :    eeNews on Google News


Linked Articles