Hall effect torque sensor targets electronic power steering

Hall effect torque sensor targets electronic power steering

New Products |
By Christoph Hammerschmidt

The SX-4462 fourth-generation Magnetorque (MT4) is easy to integrate, leveraging TT’s system expertise and development support. Additional flexibility is provided by customisation options including full-scale range and sensitivity, wire length, product marking and connector type. The 4.5V-5.5V supply voltage range simplifies connection to a convenient power source, and the maximum current of just 20mA ensures always-low power consumption. Redundant outputs that allow full diagnostics and output voltage clamps that enable open/short detection ensure flawless performance under the toughest use conditions.

TT’s MT4 Magnetorque family of torque sensors allows tactile steering control, unaffected by vibration, contamination or wear factors that impair ordinary contacting sensors. It is ideal for off-road vehicles, including all-terrain vehicles (ATVs) and utility terrain vehicles (UTVs), as well as industrial vehicles used in locations such as quarries, factories, farms, or construction sites.

Weighing just 82 grams, the SX-4462 is engineered for high linearity near the zero-degree position, and torque angle of ±5°, it performs multi-turn measurement over ±2.5 turns with typical sensitivity of up to 0.4 V/°.

For further information visit:


If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :    eeNews on Google News


Linked Articles