Hand-held, portable 3D antenna spans 9 kHz to 6 GHz for detail spectral searches
The antenna works on the fly and is a plug and play solution to enable rapid 3D measurements. The antenna requires no software installation, no power connection and no hardware changes. It is connectable via the N (male) connector to any analyzer or oscilloscope.
Each IsoLOG 3D Mobile includes an internal, rechargeable battery, providing a run-time of 6 hours, and a switchable low noise bypass preamplifier. The integrated amp allows measurements of very low-level signals. Used in bypass mode, the antenna is also usable for high field-strengths. Control of the antenna is via USB; or via manual antenna selection mode, requiring no USB connection.
Aaronia has also integrated an ultra fast adjustable “chopper” function. Using glitch-free RF switches this feature offers an automatic continuous antenna rotation/selection with a switching speed of up to 50 kHz. This feature transforms the IsoLOG 3D Mobile into a fully functional 3D antenna without the need of any USB software control.
Key parameters include;
Frequency range; 9kHz to 3GHz or to 6 GHz, by model
Gain (bypass mode, typ.); @70MHz: -42dB; @3GHz: -10dB
Gain (pre-amp on, typ.); @70MHz: -22dB; @3GHz: 10dB
Chop/Switch Speed Rate; 1 Hz to 50 kHz
Nominal impedance; 50 Ohm
Shipped in a waterproof transport-case, the unit comes with a pistol grip with tripod functionality.
Aaronia AG; www.aaronia.de
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
