Hubble space telescope restored after power device failure
NASA has successfully switched to backup power hardware on the Hubble Space Telescope, including powering on the backup payload computer.
The switch included bringing online the backup Power Control Unit (PCU) and the backup Command Unit/Science Data Formatter (CU/SDF) on the other side of the Science Instrument and Command & Data Handling (SI C&DH) unit. The PCU distributes power to the SI C&DH components, and the CU/SDF sends and formats commands and data.
Other pieces of hardware onboard Hubble were switched to their alternate interfaces to connect to this backup side of the SI C&DH. Once these steps were completed, the backup payload computer on this same unit was turned on and loaded with flight software and brought up to normal operation.
The Hubble team is now monitoring the hardware to ensure that everything is working properly. The team has also started the process for recovering the science instruments out of their safe mode configuration. This activity is expected to take more than a day as the team runs various procedures and ensures the instruments are at stable temperatures. The team will then conduct some initial calibration of the instruments before resuming normal science operations.
When the payload computer halted last month, Hubble’s science instruments were automatically placed into a safe configuration. A series of multi-day tests, which included attempts to restart and reconfigure the computer and the backup computer, were not successful, but the information gathered from those activities has led the Hubble team to identify the PCU as the problem.
The PCU sits on the SI C&DH unit and provides a steady voltage supply to the payload computer’s hardware. The PCU contains a power regulator that provides a constant five volts of electricity to the payload computer and its memory. A secondary protection circuit senses the voltage levels leaving the power regulator. If the voltage falls below or exceeds allowable levels, this secondary circuit tells the payload computer that it should cease operations. The team’s analysis suggests that either the voltage level from the regulator is outside of acceptable levels (thereby tripping the secondary protection circuit), or the secondary protection circuit has degraded over time and is stuck in this inhibit state.
Because no ground commands were able to reset the PCU, the Hubble team switched over to the backup side of the SI C&DH unit that contains the backup PCU. The team performed a similar switch in 2008, which allowed Hubble to continue normal science operations after a Command Unit/Science Data Formatter (CU/SDF) module, another part of the SI C&DH, failed. A servicing mission in 2009 then replaced the entire SI C&DH unit, including the faulty CU/SDF module, with the SI C&DH unit currently in use.
Replacing the module is no longer an option, but the next generation space telescope, the James Webb, is scheduled for launch in the autumn.
- Space factory for power wafers
- First US government contract for Ruag Space targets power
- Radiation hardened isolated DC-DC converter for space
- COTS DC-DC converter family is rad hard for space
- Europe in dramatic €13bn space shake up
Other articles on eeNews Power
- Coventry steps up battery battle
- Svolt in battery Gigafactory deal with Stellantis
- Skeleton’s graphene ultracapacitors to power trams
- EU signs deal with Ukraine to secure lithium supplies for EV batteries
- Verkor raises €100m ahead of a battery gigafactory in France
- Cirrus Logic buys Lion Semiconductor for switched capacitor power
- Stellantis bets €30bn on solid state batteries