Infineon kit offers ‘fast and easy’ motor drive design
The kit includes controller and power boards – sensor-less or optionally with sensors. Using the kit, a full functioning motor system will be running in less than one hour, enabling fast time to market. Designers only need a few steps to run the motor: plug the cards into their PC, motor and grid, download, install and parameterize the software.
Infineon offers four kits which match different motor designs. Every kit includes a control card with debug interface, complete power stage including rectifier and EMI filter. The motor control software is preloaded or available for download, and features a GUI software for parameterization and tuning. Via a standardized M1 20-pin MADK Platform interface connector, various combinations of control and power boards can be realized to best match different application requirements.
Field Oriented Control (FOC) software supports sensor-less motor control based on the XMC1302 microcontroller. The hardware is also supporting the use of Hall sensors or 3D magnetic sensors. The XMC1302 control card includes a debugger based on Segger J-Link technology. Additionally, the software support for this tool includes an easy to use μC-Probe based GUI. Further application software development can be implemented via DAVE, Infineon’s free-of-charge integrated development environment (IDE), or with major ARM IDEs, such as Keil, IAR or Atollic.
A further control option is available with the IRMCK099M, a motion control ASIC with hardware-based sensor-less FOC control. It comes with a separate debug interface card. Available kits combine the XMC1302 control card with one of four power boards from the μIPM IRSM836 series or μIPM-DIP IRSM505 series (500V or 250V).
Infineon; www.infineon.com/MADK
This link also leads to full software packages for each kit as well as additional information on the iMotion MADK.
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
