Load switch chip integrates voltage detector

Load switch chip integrates voltage detector

New Products |
By Christoph Hammerschmidt

The actual switching element of the R5542 consists of an N-Channel MOSFET and is controlled by the LCE input to switch the power rails. Other advantages of a load switch are the possibility to set up a specific power-on sequence of various power supplies but also the total BOM count and total required board-space is significantly reduced. Measuring 1.68×1.28×0.65mm, the load switch consumes typically 10µA in On-mode and 1µA in Off-mode. An additional voltage detector on board makes it possible to control the load switch when exceeding a specific voltage threshold. All voltage detector terminals are isolated from the load switch, so it can be configured and powered independently (by the VDI input). A delay can be created on the output by adding a resistor and capacitor on the VDO output. Users can select the threshold in a range from 2.0 to 5.5 V in a 0.1 V step.

Ricoh Electronic Devices –

If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :    eeNews on Google News


Linked Articles