Medical configurable power supply offers 1 x MOPP from input to earth
The improved products now allow customers to isolation test self-configured power supplies from input to output to 6 kV DC.
The enhancements include the introduction of Y1 capacitors and Type Testing at 5675 V DC (the DC equivalent of 4 kV AC), from input to output. Carrying full UL60601-1 and EN60601-1 3rd edition approvals, the range provides low leakage current (less than 150 µA available) as well as meeting the stringent creepage and clearance requirements of medical equipment. All products come with the industry leading three year warranty.
Dielectric testing is a simple method of verifying the adequacy of electrical insulation to withstand the peak voltages that can occur during transient events. However this can be a destructive test and is generally categorized as a ‘Type test’. ‘Type tests’ are investigations carried out by Safety Agencies and are intended to prove that the construction of the power supply meets the requirements dictated by the relevant safety standard. However, Reinforced (primary to secondary) Insulation cannot be tested without over-stressing basic insulation on the end product and it is because of this the agencies allow manufacturers to test reinforced insulation separately. This means they are allowed to test transformers and other primary to secondary isolation barriers separately before components are incorporated into the product.
The enhanced range of medically approved Xgen power supplies has been specifically designed to withstand the DC peak equivalent of the 4kV AC isolation test from primary to secondary. (Note: Refer directly to UL60950-1, C5.2.2 or UL60601-1 2nd Edition Section 20.4 or IEC60601-1 3rd Edition Section 8.8.3 for more information). By selecting this Excelsys product range customers can test in-situ with a DC voltage of 6kV applied across the isolation barrier of a fully assembled power supply. Excelsys will continue to carry out 100% production testing of all primary to secondary isolation barriers on all Xgen products. This will directly address the growing demand from customers to verify the isolation barrier on their application without causing an electrical stress on internal components.
The Excelsys Xgen series of medically approved power supplies can provide up to 1340 W watts of output power with DC voltages in user selectable combinations from 1.5 V to 58 V each with individual output control. The series has leakage current of less than 300 µA, and the option of less than 150 µA. All outputs are fully floating allowing series/parallel connection of all multiple outputs for non-standard voltages or higher output current. Xgen power supplies may be connected in parallel for higher system power requirements and a 5 V bias standby voltage is provided on all models.
Availability
Sample products are available immediately and production quantities are available from May 2012.
Visit Excelsys Technologies at www.excelsys.com
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
