MEMS variable capacitive accelerometers with 4-wire snap-in removable connector
The model 2266 is expressly tailored for zero-to-medium frequency applications and offers integral amplification and high-drive, low impedance buffering for precision measurements. The accelerometer produces two analog voltage outputs and supports both single ended and differential modes. Signal outputs are fully differential about a 2.5V common mode voltage. Sensitivity is independent from the supply voltage of +8 to +32V. At zero acceleration, the output differential voltage is nominally 0 VDC; at full scale acceleration, the output differential voltage is ±4 VDC.
The sensors feature on-board voltage regulation and an internal voltage reference which eliminates precision power supply requirements. The sensor is relatively insensitive to temperature changes and thermal gradients. Self-calibration is quick and easy. Within standard range (2 g to 400 g), most accelerometers continue to operate after sustained exposures of up to 10K g shock and with limited exposure to temperatures above +200°C. Carefully regulated manufacturing processes ensure that each sensor is made to be virtually identical, allowing users to swap out modules with minimal modifications.
The low-impedance outputs of the Silicon Designs model 2266 will drive more than 100 meters of cable, with an overall flexibility that allows them to be used within a wider variety of applications without having to undo any wiring or replace cables.
Get the data sheet at www.silicondesigns.com/ds/ds2266.html
Visit Silicon Designs at www.silicondesigns.com
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
