Microchip MPLAB Snap Dev Tool, Now at Mouser
The MPLAB Snap targets most PIC, AVR and SAM flash microcontrollers and dsPIC digital signal controllers (DSCs), using the MPLAB X IDE GUI.
The MPLAB Snap board has a 32-bit 300 MHz SAM E70 Arm Cortex-M7 based MCU for quicker debug iterations. The debugger system executes code in the same way as an actual device, because it uses the target device’s built-in emulation circuitry instead of a special debugger chip.Available features of the device can be set and modified by the MPLAB X IDE interface. The board also matches the clock speed of the target device.
Along with support for a wide target voltage range of 1.20V to 5.5V, the MPLAB Snap supports interfaces such as 4-wire JTAG and Serial Wire Debug with streaming data gateway. It is also backward compatible for demo boards, headers and target systems using 2-wire JTAG and ICSP.
More information
www.mouser.com/microchip-mplab-snap
Related news
Mouser adds Microchip’s dsPIC33CH dual-core Digital Signal Controllers
Microchip’s MPLAB Xpress dev board shipping from Mouser
Dual-core dsPIC controller enables separate code design and higher levels of integration
New 2D Touch Surface library for embedded applications
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :