Micromechanical 6DoF combo sensor features power-saving wake-up on motion function
In normal operation mode, current consumption of the SD746 is approximately 6 mA. In sleep mode, by reducing the sample frequency of the three axes acceleration sensor from 8 Hz to 1 Hz, current consumption is only 25 µA. Through three digital interfaces of the SD746, the user can set an individual threshold for the acceleration. As soon as in sleep mode the acceleration detected on at least one axis is greater than the threshold set, a corresponding output signal is generated which triggers a system activation. Furthermore, the SD746 also includes a special power-off mode in which power consumption is zero while the SPI interface remains at high-impedance levels so that the sensor need not be separated from the bus.
The SD746 comes in a QFN 40 package and offers six degrees of freedom (6DoF) for measurement of angular rate and acceleration along all three axes over a wide measurement range of up to ±2048°/s for angular rate and up to ±8g for acceleration. The temperature-compensated and calibrated measurement values can thereby either be read out via I²C or SPI interface.
The SD746 is designed for an operating voltage of 2.55 V to 3.6 V and an operating temperature range from -40 to +85°C. The maximum offset error at room temperature is ±5°/s for the angular rate signal and ±0.05g for the acceleration signal. The maximum sensitivity error at room temperature is ±2% for both the angular rate and acceleration signals.
Visit Gleichmann Electronics at www.msc-ge.com.
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
