Multiservice line card adaptive clock translators support wide range of wired communications applications
The new clock translators outperform traditional PLL (phase-locked loop) designs that require the addition of expensive VCXOs (voltage-controlled crystal oscillators).
The built-in programmability of the AD9557 and AD9558 clock translators allow network line card designers to use the same component in many different board designs, limiting the number of components needed and reducing overall system cost. This includes synchronization for a wide variety of high-performance applications, including data communications, next-generation wired networking applications, telecommunications, test and measurement, high speed data acquisition and wireless base station controllers.
The AD9557 and AD9558 clock translators integrate an on-chip, low-phase-noise, frequency-agile VCO and loop filter along with dynamic adaptive clock support. Adaptive clocking allows the DPLL (digital PLL) divider ratios to be changed while the DPLL is locked. This enables the frequency value at the output to be dynamically adjusted by up to +/- 100ppm from the nominal output frequency without manually breaking the loop and reprogramming the part with a sub 0.1 ppb step in frequency resolution.
The adaptive clock function is used for applications such as SDH to OTN mapping/demapping and asynchronous mapping/demapping. The adaptive clock translators’ programmable DPLL supports loop bandwidth from 0.1 Hz to 5 kHz and features three separate programming modes for ease of use and flexibility. The two devices are pin- or soft-pin pre-configured to support popular SONET/SDH, Ethernet, Synchronous Ethernet and Fiber Channel frequencies, while SPI (serial port interface) and I 2 C ports are available to program customised input-to-output frequency translation.
At 6 mm x 6 mm and 9 mm x 9 mm in size, respectively, the AD9557 and AD9558 clock translators provide compact, frequency agile, cost effective clocks for line card designers. The AD9557 features two reference inputs (single-ended or differential) and two pairs of clock outputs. Each output pair is configurable as a single differential LVDS/HSTL output or as two single-ended CMOS outputs. The AD9558 offers the same features but with four reference inputs and six pairs of clock outputs.
Availability and Pricing
The AD9557 clock translator packaged in a 40-lead LFCSP 6 mm x 6 mm is in full volume production now and is priced at $15 each per 1,000. The AD9558 clock translator packaged in a 64-lead LFCSP 9 mm x 9 mm is in full volume production now and is priced at $16.25 each per 1,000.
More information about the AD9557 and AD9558 clock translators at
www.analog.com/AD9557 or www.analog.com/AD9558
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
