New DAQ module for distributed measurement architecture

New DAQ module for distributed measurement architecture

New Products |
By eeNews Europe

The E-ACC is a compact device that consists of an analogue front end with 18 kHz alias-free bandwidth, 24 bit ADC converter with up to 40 kS/s sample rate and EtherCAT interface. EtherCAT allows devices to be placed up to 50m apart. These devices can then be daisy-chained using a single cable for signal and power. Synchronization below 1 µs is ensured along a virtually-unlimited chain of MonoDAQ E-ACC devices.

Each MonoDAQ-E device has a fully isolated front end with high dynamic performance as well as TEDS support for sensor auto-recognition. The devices come with DEWESoft software to allow measurement of metrics, including acceleration, force, pressure and temperature. Analogue, digital, GPS and video signals can be measured in the same environment and synchronized easily.

More information

Related news

DAQ digitisation, waveform generation and fast digital I/O run under Linux

High resolution, cost-effective PCIe DAQ cards

NI’s 2015 DIAdem DAQ software promises smarter measurement and data management

Gigabit Ethernet FPGA Module for control and DAQ functions

If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :    eeNews on Google News


Linked Articles