Non-contact laser sensor for demanding measurement and quality control inspections
The new LH features target displacement or thickness measurement with high resolution 4-20 mA or RS-485 serial communication outputs. Two sensors can be configured to self-synchronize for thickness measurements, performing the thickness calculation within the sensors, requiring no external controller for operation. The LH can be used in a network of up to 32 sensors, providing the capability to perform multiple, simultaneous inspections. Plus, with a narrow laser spot, the LH easily aligns to the smallest of targets.
The device comes equipped with an intuitive graphical user interface which guides the user through setup and performance monitoring when adjusting the sensor parameters. After the LH is installed, the GUI provides data acquisition tools to graphically display the current measurements. Parameters such as analog output scaling, averaging, sample size and other advanced features can all be set within the GUI. All data is displayed in real time and can be saved to a log file, which is useful for troubleshooting the installation.
Visit Banner Engineering at www.bannerengineering.com
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
