OCXO delivers ±5 ppb stability in a 14 x 9 mm package
In addition to this exceptional size/performance ratio the OCXO is available in a very wide frequency range from 10 to 100 MHz. Operating from a 3.3 V supply voltage, the IQOV-162 consumes 600 mA of current during warm up and takes less than 5 minutes to be within <100 ppb of the final specification and 300 mA maximum at steady state at 25°C.
The output can be specified as either HCMOS, 15 pF load or Sinewave, into a 50 Ohms load. As well as offering phase noise performance better than -150 dBc/Hz at 1 kHz offset, ageing performance is also extremely good at less than ±500 ppb per year.
Variants can be specified to include voltage control to enable the frequency to be adjusted for correction over time and remotely with a pullability range of ±3 ppm to ±8 ppm.
Typical applications include CDMA base stations, femtocells, optical networking, 3G and 4G LTE, Ethernet, SoNET/SDH, ATM backplanes, SATA and satellite communications, or whenever a very low profile OCXO is required.
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
