The researchers are claiming a three-fold increase in the efficiency of the cell technology compared with traditional solutions.
Yan Jin, a UC doctoral student in the materials science and engineering program, Department of Biomedical, Chemical, and Environmental Engineering, presented the research results this week at the American Physical Society Meeting in San Antonio, Texas, USA.
Jin will present on how a blend of conjugated polymers resulted in structural and electronic changes that increased efficiency three-fold, by incorporating pristine graphene into the active layer of the carbon-based materials. The technique resulted in better charge transport, short-circuit current and a more than 200-percent improvement in the efficiency of the devices.
“We investigated the morphological changes underlying this effect by using small-angle neutron scattering (SANS) studies of the deuterated-P3HT/F8BT with and without graphene,” explained Jin.
The partnership with the Oak Ridge National Laboratory, U.S. Department of Energy, is exploring how to improve the performance of carbon-based synthetic polymers, with the ultimate goal of making them commercially competitive.
Unlike the silicon-or germanium-powered solar cells on the market, polymer substances are less expensive and more malleable. “It would be the sort of cell that you could roll up like a sheet, put it in your backpack and take it with you,” explained Vikram Kuppa, Jin’s advisor and a UC assistant professor of chemical engineering and materials science.
One of the main challenges involving polymer-semiconductors is that they have lower charge transport coefficients than traditional, inorganic semiconductors, which are used in the current solar technology. Although polymer cells are thinner and lighter than inorganic devices, these films also capture a smaller portion of the incoming light wavelengths and are much less efficient in converting light energy to electricity.
UC doctoral student researcher Yan Jin is photographed with her advisor, Assistant Professor Vikram Kuppa. UC Assistant Professor Vikram Kuppa and Yan Jin.
“Our approach is significant because we have now shown peak improvement of over 200 percent on a few different systems, essentially a three-fold increase in the efficiency of the cell by addressing the fundamental problem of poor charge transport,” said Kuppa.
Jin led the research conducted at Oak Ridge National Laboratory and at UC’s Organic and Hybrid Photovoltaics Laboratory in the UC College of Engineering and Applied Science (CEAS). “We’re finding that these enhancements resulted from improvements in both charge mobility and morphology,” explained Jin. “The morphology is related to the physical structure of the blend in the polymer films and has a strong impact on the performance and the efficiency of the organic photovoltaic (OPV) cells.”
The technical storage or access is strictly necessary for the legitimate purpose of enabling the use of a specific service explicitly requested by the subscriber or user, or for the sole purpose of carrying out the transmission of a communication over an electronic communications network.
The technical storage or access is necessary for the legitimate purpose of storing preferences that are not requested by the subscriber or user.
The technical storage or access that is used exclusively for statistical purposes.The technical storage or access that is used exclusively for anonymous statistical purposes. Without a subpoena, voluntary compliance on the part of your Internet Service Provider, or additional records from a third party, information stored or retrieved for this purpose alone cannot usually be used to identify you.
The technical storage or access is required to create user profiles to send advertising, or to track the user on a website or across several websites for similar marketing purposes.