MENU

SuperSpeed USB-to-FIFO bridge ICs easy evaluation

SuperSpeed USB-to-FIFO bridge ICs easy evaluation

New Products |
By eeNews Europe



Measuring 78.7x60mm, the UMFT600A and UMFT601A each have a high speed mezzanine card (HSMC) interface with 16-bit and 32-bit wide FIFO buses respectively.

The UMFT600X and UMFT601X measure 70x60mm and incorporate field-programmable mezzanine card (FMC) connectors, again with 16-bit and 32-bit wide FIFO buses respectively. The HSMC interface is compatible with most Altera FPGA reference design boards, while the FMC connector delivers the same functionality in relation to Xilinx boards.

Fully compatible with USB 3.0 SuperSpeed (5Gbits/s), USB 2.0 High Speed (480Mbits/s) and USB 2.0 Full Speed (12Mbits/s) data transfer, the UMFT60xx modules support 2 parallel slave FIFO bus protocols with an achievable data burst rate of around 400MBytes/s. The multi-channel FIFO mode can handle up to 4 logic channels. It is complemented by the 245 synchronous FIFO mode, which is optimised for more straightforward operation.

Visit FTDI Chip at www.ftdichip.com

If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :    eeNews on Google News

Share:

Linked Articles
10s