Test strategy for ONFI flash memory standard

Test strategy for ONFI flash memory standard

New Products |
By Graham Prophet

Available for Tektronix high-performance oscilloscopes, the ONFI 4.0 test solution includes software for analyzing DDR2/3 modes on the ONFI bus coupled with an effective probing solution based on interposers.


The ONFI 4.0 spec introduces the evolutionary NV-DDR3 interface with VccQ = 1.2V operation for increased performance and improved power consumption, scales NV-DDR2 and NV-DDR3 I/O speed to 667 MT/sec and 800 MT/sec, and adds ZQ calibration functionality.


As the speeds have increased and voltage levels have dropped, designers working with the ONFI bus face challenges to ensure compliance, debug timing problems and gain access to signals. TEK-PGY-ONFI software enables design and test engineers to test the ONFI interface for compliance to ONFI bus timing parameters and provides automated measurements of Command, Address, Data in and Data out transactions. A detail view feature in the TEK-PGY-ONFI software correlates each electrical measurement of an ONFI waveform by annotating it with the analogue waveform to help debug timing problems.


Dense packaging and high data rates make gaining high-fidelity signal access to NAND flash devices challenging. Tektronix offers support for a range of different mechanical form factors including socketed, direct attach and a patented edge probe design for extremely tight mechanical requirements. S-parameter models of interposers and probes are available for modelling or to generate de-embedding filters to be applied to the oscilloscope.


TEK-PGY-ONFI software runs on the Tektronix MSO/DPO70000 Series oscilloscopes with bandwidth of 4GHz -33GHz and recommends the P7500 or P7300 Series probes for testing. For some engineers testing for ONFI, signal access may be poor or not available at all, therefore, Tektronix recommends ONFI 152 ball NAND Flash Edge high fidelity interposers from Nexus to achieve signal access while maintaining signal integrity.


The new TEK-PGY-ONFI software adds to the Tektronix’ offerings for other memory technologies including eMMC, UFS and DDRA. Tektronix TEK-PGY-ONFI software for Tektronix oscilloscope and interposers starts at $8000 for the software only. Free trial licenses are available.





If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :    eeNews on Google News


Linked Articles