Tiny ovened crystal delivers ±5 ppb stability
This model is available in a frequency range from 10 to 100MHz. Operating from a 3.3V supply, the IQOV-162 consumes 600 mA of current during warm up and takes less than 5 minutes to be within <100ppb of the final specification; it uses 300 mA max at steady state @25 degrees C.
The output can be specified as either HCMOS, 15 pF load or sinewave, into a 50 Ohms load. As well as offering phase noise performance better than -150 dBc/√Hz @ 1kHz offset, ageing performance is also extremely good at less than ±500 ppb per year.
Variants can be specified to include voltage control to enable the frequency to be adjusted for correction over time and remotely with a pullability range of ±3 ppm to ±8 ppm.
The IQOV-162 series is primarily designed to be used in applications such as CDMA base stations, femtocells, optical networking, 3G & 4G LTE, Ethernet, SoNET/SDH, ATM backplanes, SATA and satellite communications, or whenever a very low profile OCXO is required.
IQD; www.iqdfrequencyproducts.com/
If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :
