Wide-input, 0.5-A linear regulator withstands temperatures up to 210 degrees C

Wide-input, 0.5-A linear regulator withstands temperatures up to 210 degrees C

New Products |
By eeNews Europe

The current-sharing feature of the 3-A TPS7H1101-SP and the 0.5-A TPS7H1201-HT allows designers to use two devices in parallel for twice the output current. The devices also offer excellent noise performance, as well as minimize thermal dissipation and increase power efficiency for optimal system reliability.

The TPS7H1101-SP LDO is QML Class V-qualified up to 125 degrees C for harsh environments, such as high-reliability medical equipment, satellites and undersea cabling. The TPS7H1201-HT LDO is qualified up to 210 degrees C for high-temperature applications, such as downhole drilling.               

Two TPS7H1101-SP LDOs used in parallel can output up to 6 A, while  two TPS7H1201-HT LDOs can output up to 1 A. Sharing the current equally between the matching LDOs reduces stress on the components to meet higher current demands, and time between failures is reduced by half.

The devices offer more than 80 percent better thermal performance than similar solutions offered today. The enhanced thermal packaging minimizes thermal temperature for higher reliability.  

The 1.5-V to 7-V input allows voltage support for power rails below 3.3 V.

The low dropout performance of 75 mV at 1 A allows for minimal input-to output-voltage conversion for reduced power dissipation.

The devices deliver low output noise of 17 uVrms, coupled with a high power supply rejection ratio of 45 dB at 1 kHz, supports noise-sensitive applications, such as medical equipment and oil and gas exploration equipment.

The TPS7H1101-SPEVM and the TPS7H1201-HTEVM evaluation modules (EVMs) are available to test performance at different input and output voltages and various load conditions.

The TPS7H1101-SP and the TPS7H1201-HT join TI’s portfolio of products for harsh environments. To supply power to the LDOs, TI offers the 6-A TPS50601-SP and the 3-A TPS50301-HT monolithic point of load converters, both supporting input voltages from 1.6 V to 6.3 V.

A SPICE model is also available for designing, testing and troubleshooting a broad variety of basic and advanced circuits, including complex architectures, without any node or number of device limitations.


The TPS7H1101-SP and the TPS7H1201-HT are available now in a 16-pin thermally enhanced ceramic flat pack (CFP).

More information about the TPS7H1101-SP and the TPS7H1201-HT linear voltage regulators at

If you enjoyed this article, you will like the following ones: don't miss them by subscribing to :    eeNews on Google News


Linked Articles