Picotest bundle supports FRA features across multiple instruments

July 22, 2019 //By Julien Happich
Picotest bundle
Picotest has released a new ‘FRA Bundle’ of signal injectors that enables Bode plots and PSRR (power supply rejection ratio) measurements for Keysight, Tektronix, Siglent, and Rohde & Schwarz oscilloscopes.

“Traditionally Bode plots and PSRR measurements have been made on Vector Network (VNA) or Frequency Response Analyzers (FRA). But recently scope manufactures have begun to add FRA features to oscilloscopes, expanding their measurement capabilities. While the software add-ons enable new FRA features, without our injectors end-users can’t actually make the measurements” according to Steve Sandler, Picotest CEO. “The FRA bundle provides the signal injectors needed to connect the scope to the DUT.”

The Picotest FRA Bundle works with the Keysight InfiniiVision X-Series with the power measurements option, Tektronix 5 or 6 series oscilloscopes using the 5-PWR or 6-PWR software, Siglent SDS1000X-E-FG series scopes with the appropriate firmware and SAG/SDG AWG support, and Rohde & Schwarz R&S RTM, RTA, and RTB oscilloscopes using the R&S RTx-K36 FRA option. The software options alone do not enable these control loop measurements. The stimulus signals from the oscilloscope or AWG to the power supply under test must be injected and this requires Picotest injectors.

The FRA Bundle includes the J2100A injection transformer. This injector enables Bode Plots; without an injection transformer it is not possible to break the control loop of the power supply and, therefore, cannot make the measurement even though the software may be installed. The J2100A works from 10Hz - 5MHz, high enough for most power supplies – a 23 Octave range, with low distortion and support for 5 Ohm terminations that have minimum loop impact. The FRA bundle also includes the J2120A line injector. The J2120A enables PSRR measurements; it allows combination of the ripple signal with the power rail voltage for injection into the DUT with a 10Hz-10MHz usable bandwidth, low loss design and 5 Amps/50VDC capability.

Vous êtes certain ?

Si vous désactivez les cookies, vous ne pouvez plus naviguer sur le site.

Vous allez être rediriger vers Google.